Skip to consent manager Skip to main content Skip to search Skip to category navigation Skip to footer
Ubiquiti Networks

Ubiquiti ETH-SP-G2 | Ethernet Lightning Protection

Low-cost insurance for your network. The Ubiquiti ETH-SP-G2 is an affordable yet effective surge protector for all outdoor networking devices. Whether airFiber, airMAX, or UniFi cameras – this small device protects your expensive hardware from electrostatic discharge (ESD) and voltage spikes caused by thunderstorms. The ETH-SP-G2 supports Gigabit Ethernet and PoE (Power over Ethernet), ensuring it doesn't slow down your connection speed. It is weatherproof and easy to mount on poles or walls. Investing in an ETH-SP-G2 is minimal compared to the damage a single nearby lightning strike can cause.


Highlights

  • Protection: Safely diverts dangerous surges and ESD into the ground.
  • Gigabit & PoE: Full 1000 Mbps throughput and PoE passthrough (up to 50V).
  • Plug & Play: Easy installation between antenna and router/switch.
  • Outdoor-Ready: Weatherproof housing for pole mounting.
  • High Surge Capability: Absorbs surge currents up to 10 kA.
  • Universal: Works with any Ethernet device (not just Ubiquiti).


Do you have questions about the ETH-SP-G2 surge protector? Then just ask us!


15,99 €
incl. 19% VAT , plus shipping costs
Available immediately
Delivery time: 2 - 3 Workdays (DE - int. shipments may differ)
Ubiquiti Ethernet Surge Protector Generation 2
Ubiquiti ETH-SP-G2 | Ethernet Lightning Protection
15,99 € *

Ubiquiti ETH-SP-G2: The Bodyguard for Your Hardware

Any device mounted outdoors is vulnerable to voltage spikes. It doesn't even have to be a direct lightning strike – a nearby storm or dry wind can build up static charges that travel down the network cable straight into your expensive server room or living room switch.
The ETH-SP-G2 prevents this. It acts as a barrier.

How It Works

Inside, Gas Discharge Tubes (GDT) are at work. As soon as the voltage on the cable exceeds a critical value (approx. 90V), the tube ignites and diverts the energy instantly via the grounding cable before it reaches the sensitive chip of your router.

No Brake on Your Network

Many cheap surge protectors throttle speeds to 100 Mbps.
The ETH-SP-G2 is fully Gigabit capable. It protects all 8 pins of the network cable and lets PoE (Power over Ethernet) pass through unimpeded. You can use it without issues for high-performance antennas like the airFiber 5XHD or 4K cameras.

Installation Tip

For maximum protection, Ubiquiti recommends using two units: 1. One near the antenna (diverts static build-up from the air). 2. One just before entering the building (protects the indoor switch).
Important: The protection only works if the included grounding wire is connected to a proper ground (potential equalization bar or mast ground)!



Detailed Technical Specifications

System & Performance
Model:ETH-SP-G2 (Generation 2)
Interfaces:2x RJ45 (Female) - 1x In / 1x Out
Ethernet Speed:10/100/1000 Mbps (Gigabit)
PoE Support:Yes, IEEE 802.3af/at/bt & 24V/48V/50V Passive PoE
Protection Ratings
ESD/EMP Protection:Absorbs transient currents (100 V/s to 1 kV/µs)
DC Spark-Over Voltage:90 V @ 100 V/s
Impulse Spark-Over:700 V @ 1 kV/µs
Discharge Current:5 kA (10x) / 10 kA (1x) (8/20 µs waveform)
Capacitance:< 1.0 pF @ 1 MHz (extremely low, thus no signal loss)
Physical & Environmental
Dimensions:91 x 61 x 32.5 mm
Weight:80 g
Housing:Polycarbonate (Weatherproof)
Mounting:Wall or Pole (Mount integrated)
Operating Temp:-30°C to +70°C
Certifications:CE, FCC, IC, ETSI300-019-1-4 (Shock/Vibration)


Scope of Delivery

1 x Ubiquiti ETH-SP-G2
1 x Grounding Wire (approx. 30cm, ring terminal)
1 x Mounting Kit (Screws, Metal Strap)
1 x Quick Start Guide

Manufacturer information: Name: Ubiquiti Networks
Homepage: https://www.ui.com
Responsible person: Name: DAJB Hamburg GmbH
Street name: Von-Bargen-Straße 34
Postal code, City: 22041 , Hamburg
Country: Deutschland
E-Mail: hallo@dajb-hamburg.de

Write the first review for this item and help others make a purchase decision!:

Loading ...